Brake line schematic
08-28-2011, 12:40 PM
#1
4th Gear Member
Thread Starter
Join Date: Jan 2007
Location:
Posts: 1,999
Brake line schematic
Is your set up retarded like my 93 5L?
It obviously work fine, been driving it like this forever but this 3 port master is not plumbed as I would have imagined.
The third line coming out the bottom of the master cylinder goes directly to the front left brake caliper.
The 2 coming out the side of the master cylinder. Both go to the proportioning/distribution block. So 2 into the block and 2 out. The 2 out go to the right front caliper and the other to the rear.
It obviously work fine, been driving it like this forever but this 3 port master is not plumbed as I would have imagined.
The third line coming out the bottom of the master cylinder goes directly to the front left brake caliper.
The 2 coming out the side of the master cylinder. Both go to the proportioning/distribution block. So 2 into the block and 2 out. The 2 out go to the right front caliper and the other to the rear.
08-28-2011, 09:23 PM
#2
5th Gear Member
Join Date: Apr 2006
Location: NC
Posts: 2,166
Thats the way mine is. Getting ready to ditch all of it for a dual master cylinder set up though. I dont know why Ford did it that way. Kinda like why did they run the line for the rear all the way to the right side of the car before going back with it?
Thread
Thread Starter
Forum
Replies
Last Post
Matt's 95 Stang
5.0L (1979-1995) Mustang
2
10-05-2015 07:16 AM
MustangForums Editor
General Tech
0
09-25-2015 06:42 PM
